INFO
FROM " TANKS
"
<< PAGE UNDER CONSTRUCTION >>
Armoured:
SEMOVENTE
M75/18 [self
propelled gun]
This superior self
propelled gun/howitzer was the first Italian SPG produced in series
during WW2. The prototype was tested in early 1941, and production models
were
assigned to operational units later in the same year. The first vehicles
of this type
to participate in combat were assigned to two SPG artillery "gruppi"
of the Ariete
Division, and received their "baptism by fire" in early 1942.
The machine was used
in much the same way as the Germans used the Jagdpanzer, thus, the tank
served
as a anti-tank vehicle rather than it's originally designed purpose of
a infantry artillery
support vehicle. When introduced, the armament was considered formidable
in
comparison to both German and British units. The effectiveness of the
gun was further
enhanced by the use of an excellent shaped charge shell. The first units
were built on
the M 13/40 chassis with successive units built on the M14/41 and M15/42.
Production was halted in September 1943. After the armistice, the Germans
employed
any of these vehicles that they could find. Only about 200 of these units
were ever
made. The Italians used these vehicles in the post war Italian army until
they were
replaced by American equipment.
| LENGTH |
4,91 m |
| WIDTH |
2,28 m |
| HEIGHT |
1,85 m |
| WEIGHT |
13,1 ton |
| CREW |
3 soldiers |
| ARMAMENT |
1 howitzer 75/18, 1 MG Breda 30 cal. 6,5mm |
| ARMOUR |
Max. 50 mm – Min. 6 mm |
| ENGINE |
SPA 8T gasoly – 125 HP |
| SPEED |
32 km/h |
| AUTONOMY |
200 km |
CARRO
ARMATO M 13/40 [tank]
When it became
apparent that the M 11/39 did not constitute a satisfactory medium
tank, the development of a suitable successor was initiated. The basic
hull of the
m.11 was utilized, but the rest of the vehicle was much revised. The M
13/40 was
the best known of the Italian tanks used during the war, and along with
it's improved
version, the M 14/41, was the standard medium tank used by the Italian
armored forces.
The tank suffered frequent mechanical breakdowns in the desert but it
can be said
that it faired no worse than the British tanks they faced. The tank did
suffer from a very
poor power-to-weight ratio which resulted in a very low speed for it's
class.
The armor was not on par with other industrial nations, being brittle
and prone to crack
and split when hit. Armament can be said to be on par with the British
in Africa.
It held it's own against the British cruisers and the US M3 Stuart, but
was totally
outclassed by the US M3 Lee/Grant. Variations of this tank included a
prototype with a
specially equipped turret with range finding equipment. This vehicle was
intended for
artillery support. Another variant consisted (which appears to be a field
modification) of
the removal of the turret and replaced with a slightly built but fixed
structure.
This vehicle was used as a moble repair shop. 799 of these units were
produced and they
saw service in North Africa, Greece, Yugoslavia, and Montenegro.
| LENGTH |
4,91
m |
| WIDTH |
2,20 m |
| HEIGHT |
2,37 m |
| WEIGHT |
14 ton |
| CREW |
4 soldiers |
| ARMAMENT |
1 cannon 47/32,
3 MG Breda 38 cal. 8mm |
| ARMOUR |
Max .42 mm –
Min. 6 mm |
| ENGINE |
SPA 8tm 40 Diesel,
8 cilinders V, 125 Cv |
CARRO
ARMATO L6/40 [tank]
Derived from the
Fiat Ansaldo 5 ton experimental tanks, the L.6 was developed from a tank
designed by Fiat-Ansaldo for export and seen as a replacement for the
L.3 model.
An initial order for 283 was placed, but that was later reduced. Based
on a modified L.3 chassis. A 1936 prototype mounted a 37/26 gun in a left
hand hull sponson and two machine guns in the turret. Further prototypes
were built mounting a 37mm gun and a coax mounted MG in the turret. Another
variant had twin 8mm MGs in the turret.
The production model was fitted with a 20mm gun and a coax MG in the turret.
Production began in 1939 and was considered about the same as the German
PzKpfw II
in terms of firepower and general mobility. This tank was not employed
in any numbers until late in the war for Italy and it was then assigned
to cavalry divisions and
reconnaissance units. A few were sent to Russia to work with Italian units
assigned there. There was a production variant that mounted a flame thrower
in place of the 20mm gun. The command version was referred to as the Centro
Radia. This unit had 2 radios and sometimes that turret was removed and
a dummy gun was placed in the hull.
| LENGTH |
3,78 m |
| WIDTH |
1,92 m |
| HEIGHT |
2,03 m |
| WEIGHT |
6.800 Kg |
| CREW |
2 soldiers |
| ARMAMENT |
1 cannon Breda 20 mm mod.35, 1 MG Breda Mod.38 8mm
or flamethrower |
| ARMOUR |
Max. 20 mm – Min. 6 mm |
| ENGINE |
SPA 18D 4 cilinders (gasoline), 70 HP |
| SPEED |
42 km/h |
| AUTONOMY |
200 km |
AUTOBLINDA
AB 41 [armoured
car]
The AB 41 was, apart from appearance, a modification and improvement on
the AB 40. The largest change was the increase in firepower. Produced
in greater numbers than it's sisters AB 40 and AB 43, this car became
the most important Armored Car in the Italian inventory. After the Italian
surrender, RSI elements used this vehicle and when peace arrived, police
units took control of the remaining numbers. This vehicle saw service
in North Africa, Italy, Hungary, and the USSR.
| LENGTH |
5,20 m |
| WIDTH |
1,93 m |
| HEIGHT |
2,34 m |
| WEIGHT |
7,47 ton |
| CREW |
4 soldiers |
| ARMAMENT |
1 cannon Breda 20 mm mod.35, 2 MG Breda 8mm |
| ARMOUR |
Max. 18 mm – Min. 6 mm |
| ENGINE |
SPA Abm 1 gasoline, 6 cilinders in line 80 HP |
| SPEED |
75 km/h |
| AUTONOMY |
400 km |
CARRO
VELOCE CV 33 L3/38 [tank]
Although commonly referred to as a tank, this vehicle falls more properly
within the classification of a tankette. The Italian authorities showed
an interest in a small, light vehicle which would be suitable for use
in mountainous terrain, leading to the acquisition of 25 British Carden
Loyd Mark VI tankettes in 1929. A Fiat-Ansaldo modification of the Mark
VI, armed with a Fiat Model 14 water-cooled 6.5 mm machine gun was designated
as the carro i,elo(-e (CV) 29. The armament was subsequently changed to
a single Fiat Model 14 air-cooled anti-aircraft machine gun, still 6.5
mm. Subsequent modifications resulted in the CV 3/33, still armed with
a single 6.5 mm air-cooled weapon. Apart from its distinctive armament,
this first series of CV 3/33 had a characteristic track tension idler
mounted in a bracket which was attached to the rear idler wheel. In 1934,
the second series of CV 3/33 appeared, with the track tension idler separated
from the rear idler, and with two 8 mm machine guns as standard armament.
The earlier series of CV 3/33 were eventually retrofitted with the heavier
armament also. Development continued, and in 1935 the CV 3/35 appeared,
incorporating minor design and production changes, and retaining the 8
mm armament. A final version, of which only a limited number was produced,
was introduced in 1938. It differed significantly in its suspension system,
and was armed with a single Breda 13.2 mm machine gun. External stowage
of entrenching tools, etc, varied from series to series. The designation
of both the CV 3/33 and 3/35 was changed to L.3 in the late 1930s.
Variations of the L.3 were built for special applications. The most frequently
encountered variant was the flamethrower, which was built in a version
with a self-contained tank for flame liquid, and also in a version in
which a wheeled tank trailer carrying the liquid was towed behind the
CV.
| LENGTH |
3,15 m |
| WIDTH |
1,50 m |
| HEIGHT |
1,28 m |
| WEIGHT |
3.500 Kg |
| CREW |
2 soldiers |
| ARMAMENT |
2 MG Fiat mod.35 cal.8, flamethrower
or rifle AT Solothurn 20mm |
| ARMOUR |
Max. 15 mm – Min. 6 mm |
| ENGINE |
SPA CV 3 (gasoline), 43 HP |
| SPEED |
42 km/h |
| AUTONOMY |
150 km |
|